How do I setup my HPN Signature Series Heat Press?Updated 2 years ago
Once you’ve unboxed your heat press, take a minute to familiarize yourself with the different parts of the machine. The first thing you’ll need to do is install the rubber feet. Turn the heat press on its side and screw in the rubber feet onto each corner of the base. Tighten the screws of the feet with a hex key. Next, you’ll need to set the pressure to a good starting point. Perform a paper pressure test by placing a sheet of paper onto the front of the lower platen and closing the press. If the paper slides out easily then the pressure is set too low. Increase the pressure by turning the pressure adjustment knob clockwise while the heat press is in the open position. The heat press should still be able to close relatively easily but the paper should no longer slide out. Make sure that all sides of the lower platen have proper pressure. Next, plug the heat press directly into an electrical outlet. Do not use an extension cord or power strip. Also, always unplug the heat press when it is not in use. Every HPN Signature Series Heat Press comes with dual internal fuses that will protect the machine from electrical surges. Flip the red rocker switch up to power on the machine. Press the OK button on the digital computer gauge. This will allow you to set the desired temperature scale. Press the OK button again to set the temperature. Press the OK button a third time to set the time. Pressing the ok button a final time will bring you back to the real-time temperature and your heat press will begin to heat up. Pressing the reset button will reset the heat press counter to zero. Your heat press is now ready for use.