HeatPress Troubleshooting
If you find that your HPN Signature Series heat press is not heating up, it could be that an internal component may need to be replaced. If your machine is showing room temperature of around 50-100 there’s a simple test you can do to determine which
If you find that your HPN heat press is beeping continuously when you first power on the machine, it could simply be that the digital timer has reached zero. When the heat press is in the closed position the digital computer gauge will countdown to z
To install the SurePressure pressure marking system, turn the pressure adjustment knob counterclockwise until it stops. Be sure to avoid forcing the knob too far in either direction, as it may become stuck. Set the SurePressure counter to zero, then
This could either be an issue with the computer gauge or heat sensor wire. There is a wire that connects directly from the heating element and into your temperature gauge. If this wire is damaged, loose, or disconnected, your temperature display will
If you find that your Signature Series heat press is having trouble reaching your desired temperature, the back-end heat delay setting might need to be adjusted. This setting can become inaccurate if the temperature scale has ever been changed from °
All auto open models are supposed to open on their own when the timer has completed counting down. The gas shocks installed are supposed to push your upper platen up very much like the shocks on a car trunk. To resolve this problem please follow the
If you find that your Signature Series heat press is in the open position and won't stop beeping after it's powered on for the first time, it may be due to a loose connector on the digital computer gauge. This sometimes happens because of a bumpy rid
This could either be an issue with the computer gauge or heat sensor wire. There is a wire that connects directly from the heating element and into your temperature gauge. If this wire is damaged, loose, or disconnected, your temperature display will
The auto open models are equipped with electromagnets that lock your machine into place when you close down the lid. But sometimes, the pressure level can affect the magnet from working correctly. To resolve this issue please follow the steps below:
Your heat press has a timer actuator switch that engages and disengages every time you close and open your machine. Over time, the metal arm on the switch may be bent to a position that does not allow for solid contact and engagement of the timer. If
If your heat press continually heats up without stopping, this could be an indication that your solid state relay is not shutting off when it has reached the desired temperature. To resolve this please follow the steps below:
If your machine doesn’t turn on, this could either be a loose connection from shipping or your power switch and/or circuit breaker may have tripped during use. To resolve this, follow these steps: